- High Speed Centrifugal Fan
- KJ pulp pump series
- PJ type sizing pump
- CJ type coarse slurry pump series
- LMJ agitator
- XFCDL series high-pressure pump
- D. GD GR multistage centrifugal pump series
- Type S middle open pump
- IS, ISB, ISR type centrifugal pump system
- GLS type gas-liquid separation device (FPB type filtrate pump)
- Multi-disk vacuum filter
LMJ agitator
![](http://www.hzxftp.com/wp-content/uploads/2023/05/image-35.png)
The main function of agitator is to circulate and mix the slurry, so that the slurry in the slurry tank or slurry tower will not produce slurry phenomenon, so as to facilitate the slurry pumping and the use of subsequent equipment, and the slurry
The material fiber has certain functions of moistening, hydrating and dredging. LMJ agitator is mainly suitable for all kinds of slurry or white water with effective volume below 200m³ and concentration below 6% in slurry tank or slurry tower
Ring and stir
Product characteristics
1. Multiple installation methods
According to the needs of users and the structure of slurry tank or slurry tower, the installation methods of agitator can be divided into bracket type (code: P for slurry tank and T for slurry tower) and guideway type (code: PD for slurry tank and T for slurry tower)
TD) and flange connection type (code: slurry pool or slurry tower are F), among which bracket type installation needs to do agitator foundation; Stirrer foundation and motor should be made for rail installation (including rail)
Foundation: Flange connection installation does not need another foundation, can be directly fixed on the wall of the slurry pool or slurry tower with the flange, the user only needs to sit on the ground with a support
2. Agitator shaft seal form: it is mainly related to the structure configuration of agitator
The shaft seal of the mixer in the slurry pool adopts the combined seal of skeleton oil seal and packing, and the shaft seal can be cooled or without cooling water. Bracket type or guide type slurry tower agitator shaft seal with packing seal,
Cooling water is not added, but additional flushing water is needed when replacing the packing, and the packing can be replaced under the condition of not emptying the slurry in the slurry tower: flange connected type slurry tower agitator shaft seal is still with
Slurry tank agitator shaft seal is the same
3. The blade Angle can be adjusted to meet the needs of wide use. Anti-loose gasket is adopted
4. The shaft is covered with protective sleeve, and the protective sleeve is provided at the packing place to avoid the wear of the shaft
![](http://www.hzxftp.com/wp-content/uploads/2023/05/image-36.png)
![](http://www.hzxftp.com/wp-content/uploads/2023/05/image-37.png)
![](http://www.hzxftp.com/wp-content/uploads/2023/05/image-38.png)